V. 2.1

www.deltasimstudio.com                                              

Here  you will find all Deltasim news, boats, documentation and files to download.
Features:

Total dimensions: (L,W,H m.) ---------------- 120 , 25 , 39
Draft: --------------------------------------------------- 8 m.
Deadweight: ----------------------------------------- 8700 ton
Fuel: ----------------------------------------------------2300 cubic m.
Moving parts: ---------------------------------------- rudder, throttle, gauges, switches, door, hangar doors, hold doors, bow doors, blind doors, flags, windshield wipers, radars, crew, air condition
Controlled: -------------------------------------------  wipers, speed, reverse engine, turns, lights, air condition, anchor drop, all doors
Panel: -------------------------------------------------- virtual cockpits - full 3D: gauges, switches, instruments, crew
Engine: ------------------------------------------------ 2 x 4159 kW
Speed max: ------------------------------------------ 14.5 Knots
Equipment: -------------------------------------------full exterior equipment and full helm interior - equipment
Starter: ------------------------------------------------ 2x one touch switch
Helipad  ----------------------------------------------- landable
Model: ------------------------------------------------- 3 models in two variants  (six vessels)
Documentation: ------------------------------------ included
Disk space: ------------------------------------------205 Mb


Exterior model

This is faithful copy of the original ship with very detailed parts, custom effects and special, very realistic night lights.

Model 1 - Bourbon Orca SX-121



Model 2
- Bourbon Orca SX-121 Green



Model 3
- Bourbon Orca Rescue



Bourbon Orca has accurate virtual cockpit with custom gauges and moving parts. Now you can travel within whole ship - interior and exterior more
comfortable and faster - with walk acceleration. The model has adjusted 16 camera definitions for most important places on the boat.

 

The Captain Bridge

 

The Hull

 

The Equipment

 

PANEL DIAGRAM





All switches are described.

Anchoring starter block - if you drop the anchor, starter switch will be blocked. To start the engine you need to rise the anchor.

          

Door open by the knob click.  

 

Real lights for Bourbon Orca

 

LIGHTS HINT:

Bourbon Orca has more lights then FSX has possibility. Sometimes, helm light or main deck light can go out. In this case simply push the
switch again.

          
INSTALLATION

Run setup program and during the installation process - insert the registration code 

This software requires  about 204 Mb disk space

FLIGHT

In the archive file, you can find folder: FLIGHT SIMULATOR X FILES.
Copy and paste this folder to the MY DOCUMENTS, then start Flight Simulator X.
In the main menu choose FREE FLIGHT and click LOAD button then choose the flight: Deltasim_Bourbon_Orca
Vista users:
C:\USERS
\NAME\DOCUMENT


VESSEL VARIANT

The choice of  the vessel:

You have three models of the ship in two variants:  DEFAULT for fast machines and LITE for slow machines.
Test parameters:
Machine:
Pentium dual core 2x2600 MHz, 4 Giga RAM Nvidia 8800 GTS
Default version: 20 - 28 frames approx.  with default aircraft.cfg/ lite aircraft.cfg
Lite version:      28 - 36 frames approx.  with default aircraft.cfg/ lite aircraft.cfg
You get two AIRCRAFT.CFG files: DEFAULT for fast machines and LITE for slow machines - you will choose better for your machine.
The second one give you 8 - 10 frames





VERY IMPORTANT !

Before you change the variant of model or any model, switch off the engine or lower sail !

Hints:
- If you mix panel switches with keyboard keys the control light will lost correct relation of events,
I mean, if you change a variant of boat without engine stop your new variant will sail without correct
control light of engine (start-stop) - for lights simply push L key twice.
The same concern other moving parts controlled by the switches.

- If the ship can not start with engine, it's mean the wind is to strong - turn the boat around in place
with Z axis to sail with the wind or reduce the wind ( same with reverse )

HOW TO STAND THE BOAT IN THE WATER ANYWHERE YOU LIKE


1 - start with any float plane
2 - land in the water where you will sail
3 - switch off the engine(s)  !!!!!
4 - change the airplane to your boat
5 - If you want to sail in this place in a future, save your flight.
6 - sail

START PROCEDURE

Adjust SETTINGS REALISM first. To feel wind, adjust General slider to the right. If you have strange behavior  in the water - mark IGNORE
CRASHES




1 -  switch on: battery
2 -  push F1 key to set throttle at 0  -  VERY IMPORTANT !
2 -  switch ON engine 1 and engine2
3 -  sail
4 -  use throttle control for speed
5 -  for very slow sailing - use one engine only

THE  KEYS

WALK

SHIFT + ENTER  ---------------------------------------- UP
SHIFT + BACKSPACE  ------------------------------
DOWN
CTRL + SHIFT + ENTER ----------------------------- RIGHT
CTRL + SHIFT + BACKSPACE  -------------------LEFT
CTRL + ENTER ------------------------------------------ BACK
CTRL + BACKSPACE -------------------------------- FORWARD


VIEW

SPACE + MOUSE MOVING  ---------------------- THE BEST AND QUICK : ZOOM, MOVING, TURNS
F9  ------------------------------------------------------------ VC
F10  ---------------------------------------------------------- MINI PANEL
F11  ---------------------------------------------------------  TOWER
F11  ---------------------------------------------------------  TOP
A  ------------------------------------------------------------  TOGGLE CAMERA
S  ------------------------------------------------------------  TOGGLE VIEW
-   ------------------------------------------------------------- ZOOM (-)
+   ------------------------------------------------------------ ZOOM (+)
CTRL + SHIFT ------------------------------------------  TOGGLE   ZOOM  (-,+)
CTRL + SPACE  ---------------------------------------  RESET VC VIEW TO DEFAULT

VIEW BY CAMERA DEFINITION

INSIDE :               F9   >>>  SHIFT + S   >>>  A, A, A, A......
OUTSIDE :          F 10  >>>  SHIFT + S  >>>  A, A, A, A.......

ENGINE

F2  --------------------------------------------------------  REVERS ENGINE   (AND QUICK BREAK)
F3  --------------------------------------------------------  SLIGHTLY FORWARD
F4  --------------------------------------------------------  FULL POWER
F1  --------------------------------------------------------  POWER OFF
* ,  -     (NUMPAD) --------------------------------
-  ADDITIONAL BREAK

RUDDER STEERING

0   (NUMPAD) ------------------------------------------  LEFT   -------------> carefully, with sense
ENTER   (NUMPAD) ---------------------------------  RIGHT  ------------> carefully, with sense
5  (NUMPAD)  ------------------------------------------  STRAIGHT

ANY CONTROLER WITH THREE AXIS  X,Y,Z;       Z- AXIS = TURN LEFT, RIGHT


Any comments, please e-mail to:  Robert Waszkiewicz     deltasimstudio@deltasimstudio.com 
 
     
www.deltasimstudio.com                  

03.01.2009

® Copyright 2006 - 2009  by  Robert Waszkiewicz   Deltasim Studio.  All Rights Reserved.